Caspase-6 Fluorometric Assay Kit

What it means: A Fluorometric assay releases a fluorescent product, and the emitted signal is measured against an excitation/emission pair rather than by absorbance.

Why it matters:

• Fluorometric detection typically reaches one to two orders of magnitude lower than the equivalent colorimetric format, which matters for scarce or dilute samples.
• The wider dynamic range means fewer sample dilutions are needed to stay on the linear part of the curve.
• Fluorescent readouts are sensitive to autofluorescent compounds and to well-to-well light bleed, so black plates and a shielded layout help.

How to interpret here: This kit uses the Fluorometric format, so a fluorescence-capable reader with the stated filter pair is required; an absorbance-only reader will not work.

Tip: Protect the plate from light during incubation and read promptly after the stop step to limit signal decay.

What it means: The kit is read at Ex/Em = 400/505 nm, the excitation and emission pair at which the fluorescent product is detected.

Why it matters:

• Your reader must support Ex/Em = 400/505 nm; filter-based instruments need the matching filter set, monochromator instruments can be programmed directly.
• Reading outside the stated pair loses signal quickly and compresses the standard curve.
• Fluorescent compounds in the sample that overlap this pair will inflate the blank, so a sample-only control is worth including on every plate.
• Bandwidth matters as well as centre wavelength: a wide filter collects more signal but also more background from the matrix.

How to interpret here: Set the instrument to Ex/Em = 400/505 nm before starting and keep gain settings constant across the plate and between runs, since changing gain mid-study makes plates incomparable.

Tip: Fix the gain on the highest standard, then use that setting for the whole plate so readings stay comparable across the study.

What it means: The assay requires 1-2 hours, generally as one or more extended incubations.

Why it matters:

• A 1-2 hours protocol is best planned as a half-day activity with the reader booked in advance.
• Longer incubations improve sensitivity for low-abundance targets but make temperature control more important.
• Plate-to-plate timing differences become a real source of variance at this length, so staggering starts deliberately is better than trying to run everything at once.
• An incubation of this length also means the reader must be free at a predictable time, which is worth booking in advance.

How to interpret here: Schedule 1-2 hours for this kit and stagger plate starts so each plate receives the same incubation rather than the same finish time.

Tip: Use a plate sealer during long incubations to prevent edge-well evaporation, which otherwise concentrates the outer wells and biases the curve.

What it means: The kit is stored at -20°C as a complete unit.

Why it matters:

• A single -20°C storage condition means the kit can be filed intact with no need to separate components on arrival.
• A standard laboratory freezer is sufficient; no ultra-low freezer is required.
• Repeated freeze-thaw cycles still degrade enzyme and substrate components, so aliquoting is worthwhile for frequent use.
• A frost-free freezer cycles above the set point during defrost, which is harder on labile components than a manual-defrost unit.

How to interpret here: File the whole kit at -20°C on arrival and return components promptly after each use rather than leaving them at the bench between plates.

Tip: Aliquot the substrate and any enzyme component on first thaw if you expect to use the kit over many sessions, and store the aliquots in a manual-defrost freezer where possible.